CTC EcoPart 600M

Compact pump for geothermal, marine or ground source heat suitable for low ceilings where the heat pump will be located. Or if you want to connect the pump to a wood burner or other units. CTC EcoPart has neither hot water preparation nor built-in control, which makes it easy to simply replace the geothermal heat pump.

CTC EcoPart 600M adapts automatically to the building’s output requirements during the year. When high output is required, the output increases. When less output is required, the compressor shifts to lower output. This means that you will always achieve maximum savings.

CTC EcoPart 600M is a compact heat pump with same level of performance as CTC GSi 612 and 616, but without control and water heating. CTC EcoPart 600M comes in two models, which means it can be used in most properties: 612M with an output range of 2.5-12 kW and 616M with 4-16 kW.

CTC EcoPart is flexible and is designed to be connected to new or existing systems. And it’s no problem if you have an old heat pump that needs to be replaced, since the product automatically adapts to the existing borehole. Ground, bedrock and lakes are used as heat sources. The brine system can easily be connected to the right, left, top or rear of the heat pump.

If your ceiling is too low for a normal heat pump, or if you need very large volumes of hot water and heating, the perfect solution is to install CTC EcoPart 600M together with the CTC EcoZenith i550 Pro indoor module. This combination will give you a complete heat pump system with control and hot water heating and with a capacity of more than 600 litres of 40 °C hot water. Plus, the system can be expanded with pool and solar heating.

If you would like to connect CTC EcoPart 600M to your existing installation, just add the CTC EcoLogic Pro/Family control module. For particularly large energy requirements, up to ten heat pumps can be run together.